Raven SBGUIDANCE SMARTRAX MD, Руководство по установке

Страница: 27 / 48

PAGINA 27/48 | Installation manual | 016-8000-098EN | Rev. A
MOUNTING GPS AND RADIO/GSM ANTENNA | SBGUIDANCE | SMARTRAX MD
4.4 MOUNTING RAVEN 600S ANTENNA
It is also possible to use SBGuidance Auto in
combination with a Raven 600S antenna (Figure 25).
In this manual the installation of the 600S antenna is
explained. For the configuration of this antenna see
the English configuration manual: ‘016-8000-025EN-A
- Configuration manual – 600S smart antenna’.
On the bottom side of the 600S antenna, two magnets
are built-in for attaching the antenna to steel surfaces.
The new version of the GPS antenna bracket has a
slope on both sides, so that the 600S antenna is well
centered on the GPS antenna bracket (Figure 25). The
GPS antenna bracket has to be mounted on the front
of the cabin roof.
See Figure 50 for the connection schematics of the
600S cabling. An adapter/split cable is supplied with
this antenna. The antenna is connected through this
adapter cable and the ‘600S to Viper 4’ cable to the
terminal harness. The adapter cable should remain to
the GPS antenna when it is removed from the tractor.
If also a Slingshot modem is used for RTK corrections,
a ‘modem to receiver’ cable has to be connected.
Make sure that the connectors on the roof are
provided with protective caps (Figure 27). With these
protective caps no dust and water can enter the
connectors.
Furthermore, the following guidelines must be
observed when installing the GPS antenna:
 Mount the GPS-antenna with the connectors
backwards (Figure 26).

Mount the GPS-antenna at least 60
centimetres in front of the rear axle.
FIGURE 25 RAVEN 600S ANTENNE.
FIGURE 26 RAVEN 600S ANTENNA ON A CABIN.
FIGURE 27 CABLES TO THE RAVEN 600S ANTENNA.