Raven SBGuidance Side-Shift, Руководство по установке

Страница: 21 / 30

SBGuidance Side-Shift I Version 1.1 I CAN
Pag 21/ 30 I SBG-Side-Shift-IM-EN-V1.0
open the set-up screen for the CAN Side-Shift
steering (Figure 18).
The steering controller is recognized if the
status is on
Running , if an SW Version is
displayed and the correct type of STU is
detected. In addition, a sensor value should be
displayed and a yellow line should be visible in
the graphic display. The sensor value should
change when the steering system is used.
Check whether the Steering is
recognized before you continue to set up
and calibrate the Side-Shift steering.
3.2. Determine control speeds
By default, the manifold is equipped with a
proportional valve (Figure 19). When using
Side-shift steering two different types of
controls can be selected:

Proportional controls

Pulse controls
In most cases the proportional controls will work
just fine in combination with a proportional
hydraulic valve. In some cases when using
heavy machines where GPS-antenna is
mounted relatively far behind the Side-Shift
cylinder, better performance can be achieved
by using the pulse controls.
When the manifold is equipped with a
on/off hydraulic valve it’s only possible to
use the pulse controls. See chapter
3.2.2.
Figure 18 CANTool Side-Shift Steering
Figure 19 Implement manifold equipped with
proportional valve