SBGuidance Disc I Rev. A I CAN
SBG-Disc CAN-EN-Rev. A
Page 37/
50
4.
Set-up and calibration
The following software and firmware versions
are required for the set-up, calibration and use
of the CAN disc controller:
CAN-Tool 2.0.38 or more recent version.
Disc control firmware STU_DISK_3_0_38
or more recent version
SBGuidance 4.2.115 or more recent
version.
Check the download page on
software and firmware versions.
To update the steering controller
firmware, see document:
CONFIGURATION MANUAL
FIRMWARE UPDATE
CANbus controllers
016-8000-031EN
4.1.
Set-up with the CAN tool
Initialize the CAN tool. After initializing the
connection with the CAN bus, a bus load will be
displayed. The received frames must be
increasing. The bus load and received frames
are displayed at the bottom of the screen. If
not, check the wiring and connections.
Go to the tab page MyDevice and on Pre-
selection select “Navigation Controller
Figure 28 Navigation Controller (Implement)
Содержание SBGuidance Disc
