Page 34/50
I SBG-Disc CAN-EN-Rev. A
SBGuidance Disc I Rev. A I CAN
3.6.
Mounting the angle sensor
In the case of disc control, the mounting plate,
which is attached to the disc leg of the
implement for attaching the disc cylinder, is
also provided with holes for the angle sensor
bracket. The angle sensor measures the actual
disc position.
In a disc steering set, the angle sensor is
already mounted in an angle sensor
bracket (
).
3.6.1.
Mounting the angle sensor to the
sensor bracket
Follow the steps described below for mounting
the angle sensor in the angle sensor bracket
(
1.
The sensor consists of a plastic cup and
a plastic disc which both need to be
attached to the arm and the bracket
with M5 bolts. The disc needs to be
attached to the arm and the cup needs
to be attached to the sensor bracket.
The triangular notches, carved in the
disk as well as in the cup should line up
in the center position.
2.
Attach the parts in the following order:
M6 bolt, sensor bracket, washer, sensor
bracket, ring, spring-loaded ring and
locking nut.
3.
Tighten the locking nut firmly and then
loosen it a little so that the angle sensor
is able to turn freely.
Figure 23 Angle sensor in bracket
Figure 24 Angle sensor exploded view
Содержание SBGuidance Disc
