CHAPTER
6
P/N 016-5032-114 Rev. A
39
CHAPTER 6
STARTUP PROCEDURES
VERIFY THE RS1 SYSTEM INSTALLATION
1. Turn on the machine.
2. Double-check all fittings and hose connections to ensure that:
•
Hoses are not running on or interfering with moving parts.
•
Hydraulic fluid is not leaking from the system.
3. Turn the machine’s wheels fully from side to side repeatedly to remove air from the hydraulic system.
NOTE:
During the RS1 system installation, whenever the hydraulic system is purged for maintenance, or
when fittings are loosened or disconnected, air is introduced into the lines of the hydraulic system. If
air pockets are present, the wheels may not move consistently when the steering wheel is turned.
4. Continue turning the wheels until they move steadily and smoothly when the steering wheel is turned.
5. Access the System Diagnostic screen by selecting the MACHINE TEST option on the Machine Type screen and
turn the wheels using the Raven console.
NOTE:
If there are issues with the RS1 system, turn off the machine and correct them immediately. For
additional assistance, refer to the RS1 Guidance and Steering Calibration & Operation Manual
(P/N 016-4010-001) or contact your local Raven dealer.
WARNING
When starting the machine for the first time after
installing steering, be sure that all persons stand
clear in case a hose has not been properly
tightened.
WARNING
Do not use hands to check for leaks. Hydraulic
fluid under pressure can penetrate the skin and
cause serious injury or death.
