Raven OmniSeed Viper Pro, Калибровка и руководство по эксплуатации

Страница: 122 / 308

Chapter 5
110 OmniSeed™ Viper Pro™ Installation & Operation Manual
Section Control Tab
The Section Control tab is not available for standard zone mapping applications. The Section Control tab
displays the current Zone map for liquid shutoff sections.
See Chapter 8, OmniSeed Section Control , for more information about using the automatic section control
feature.
Marking a Field Feature
Recording field features, zones and boundaries for the scout map feature are all similar operations
accomplished by accessing the Scout tab during an active job. Each scout map may contain several field
features and zones to help the operator or land owner locate areas of interest at a later time or to avoid
applying chemicals in waterways or near well heads.
Note:
Refer to the Scout Tab section on page 109 for details on creating custom features for the scout
map.
If no scout map features are configured prior to starting a job, the scout map may not be used to
map any field features other than a field boundary or Section Control zones (apply or no-apply).
While several zones may be created within a field, the scout map may only contain one field boundary. When a
field boundary is completed, the Viper Pro will calculate the area contained within the completed field
boundary. Field features, zones and areas may be mapped using the following types of paths or points:
Single Point. Select the single point feature to plot a single location on the scout map. The Viper Pro
automatically plots the point at the selected location.
Note:
The point will be plotted at the vehicle location where the OK button is selected on the Record
Field Feature screen.