Cab Component Installation:
11
CAB COMPONENT INSTALLATION
CONNECT HDU AND TC1
1. Connect the 12-pin Deutsch connectors to the mating receptacles on the respective nodes.
NOTE:
Nodes are keyed to prevent connecting matching colors to the wrong node.
2. Connect the steering lockout switch to master switch assembly (PN 063-0173-961).
INSTALL THE FOOT SWITCH (OPTIONAL)
FIGURE 8. Foot Switch Installed
1. Select a suitable location for the foot switch (P/N 063-0172-470) to be installed.
NOTE:
The foot switch should be installed in a location where the operator has easy access to it and is able
to fully press the pedal.
2. Using the holes in the foot switch as a template, drill holes in the floor of the cab.
3. Secure the foot switch to the floor by installing the supplied screws in each of the mounting holes.
4. Route the foot switch cable connector to the node mounting location.
INSTALL THE MASTER SWITCH
1. Use the provided hardware to install the Master Switch (P/N 063-0173-961) in the provided enclosure.
