C
HAPTER
4
38
AutoBoom® XRT Installation Manual for Case IH Patriot 3xx0/44x0 and Trident 5550 (MY 2017-2021)
120’, 132’, AND 135’ ALUMINUM BOOM
NOTE:
Factory installed booms already have the tilt sensors installed and wired to the REM ECU. Complete
the following steps only if the boom was installed after the machine left the factory.
1. Identify the tilt sensor mounting location near the center rack on the left boom.
FIGURE 21. Left Boom Tilt Sensor Mounting Location
2. Mount the tilt sensor housing in the outside holes with the tilt sensor arm pointing in the direction of the length
of the boom.
3. Install the rod end bracket on the sensor bolt in so the rod will be parallel with the sensor arm.