C
HAPTER
4
34
AutoBoom® XRT Installation Manual for Case IH Patriot 3xx0/44x0 and Trident 5550 (MY 2017-2021)
FIGURE 15. Rotary Sensor Installation Location on Center Rack
3. Using a provided 2-9/16” x 3-1/2” U-bolt, loosely install the rotary sensor strap bracket to the upper horizontal
tube that pivots (see Figure 16 on page 34).
FIGURE 16. Rotary Strap and Sensor Bracket Installation
4. On the center frame, use two provided 3-1/16” x 4” U-bolts to loosely install the rotary sensor assembly labeled
“Center Rack 90/100 FT” to the lower horizontal tube positioned between the center rack and the center frame.
The sensor mounts on the right side of the center.
5. Install the rotary sensor link and rod end to the rotary sensor strap and secure with an M6 nylock nut.
6. Adjust the rotary sensor bracket and the rotary sensor strap until the rotary sensor arm is roughly in a vertical
orientation.
7. Tighten all hardware.
Rotary Sensor
Arm
Rotary Strap
Rod End
Upper
Horizontal Tube
Jam Nuts
Rotary Sensor
Bracket