![background image](http://html.mh-extra.com/html/raven/autoboom-xrt/autoboom-xrt_installation-manual_788970011.webp)
2
016-0236-001 Rev. E
7
INTRODUCTION
INSTALLATION OVERVIEW
The image below shows approximate installation locations for the sensor and nodes. Depending on machine
configuration and desired performance some of the sensors and dampers may not be installed.
FIGURE 2. Example Component Locations
For additional information on the component installation, refer to the:
• Hydraulic valve mounting and installation instructions in Chapter 3,
.
• Rotary sensor installation instructions in
Center Rack Rotary Sensor Installation
• Variable damper installation instructions in
• REM node installation instructions in
• ABM node installation instructions in
AutoBoom® ABM Node Installation
• Tilt sensor installation instructions in either the
on page 36, or the
120’, 132’, and 135’ Aluminum Boom
• Outer sensor installation information in
90’, 100’, and 120’ Steel Boom
• Inner sensor installation information in
90’, 100’, and 120’ Steel Boom
• Center sensor installation instructions in
90’, 100’, and 120’ Steel Boom
• Proximity sensor installation instructions in
1. Radar Sensors
2. ABM Node
3. REM Node
4. Hydraulic Valve
5. Tilt Sensor
6. Rotary Sensor
7. Variable Damper
8. Proximity Sensor
1
1
2
3, 4
6
7
5
5
8
8