Raven 98cm Elliptical Ku Antenna, Инструкция по эксплуатации

Страница: 7 / 14

1
Antenna Assembly
Complete the antenna assembly on the ground, before mounting it on the Mount Tube. This assembly
has three steps.
Step 1: Construct the
Skew Adjustment Assembly
by fastening the Skew Plate to the front of the
Elevation Bracket, through the Antenna Back Bracket. Locate the letter A on the skew plate and the
letter A on the elevation bracket. Pass five 5/16” x 1" UNC Carriage Bolts through the skew plate, then
the Antenna Back Bracket, and, finally, through the front of the Elevation Bracket. Secure the Skew
Plate using a 5/16” UNC Washer, Spring Washer, and a Hex Nut on each Carriage Bolt, as in (fig 1). Set
the antenna to 90º using the left hand scale (denoted HN) and tighten the 5 bolts with a ½” wrench to
20Nm (177 in lbf).
Figure 1