Raven 41800-002, Руководство пользователя

Страница: 11 / 33

CHAPTER 3
OPERATION
INTRODUCTION
This chapter provides the information necessary for setup, initialization, and operating the RFMOW V2. This
chapter includes:
NETWORK TERMINAL (NT)
•
Controls and indicators
•
Equipment power-up
•
Equipment power-down
•
Equipment Theory of Operation and functional diagrams
CONTROLS AND INDICATORS
The RFMOW V2 user interface is through the front panel display, pushbuttons, and indicators. These are
illustrated on page 17.
EQUIPMENT POWER-UP
WARNING
Ensure that all power connections are properly insulated, clean, and
mechanically secure to prevent personnel injury when the Unit is powered up
and operated. Carefully inspect all connectors and wiring for worn or broken
parts. Make any necessary repairs before powering up the Unit. If any cable or
connector damage is discovered while the Unit is operating, it should be
powered down and the damage repaired immediately.
Perform the following procedure to power up the Unit:
a. Ensure that power is connected to the rear panel of the chassis.
b. Install a KIV in the RFMOW V2 carrier. See page 5 for instructions.
c. Press the RFMOW ON/OFF button on the front panel to turn on the Unit (see page 17 for
location).
d. Refer to TM 11-5895-1780-13 for procedures on installing and operating the RFMOW Software
suite.
EQUIPMENT POWER-DOWN
Perform the following procedure to power-down the Unit:
a. Press the RFMOW ON/OFF button on the front panel.
b. Loosen the four thumbscrews on the front of the KIV carrier. Pull the carrier out of the chassis.
When the carrier stops press the finger releases on each side of the carrier and pull the carrier
the rest of the way out.
9