Ravelli APGL3, Руководство пользователя, Страница: 4 / 7

Using the Tripod
Set Up
To set up the tripod, Grasp the legs of the tripod, then pull each leg away from the
center until it reaches the first lock position. Do this for each leg then ensure the
tripod is stable before releasing it completely on the ground.
Mounting The Head
To install the 3 axis head, first position the
head on the head mounting plate located on
top of the center column then thread it on the
3/8" screw in a clockwise rotation until the
head is tight. Lastly, tighten the 3 Allen head
screws located underneath the mounting plate
on the center column to secure the head to
the tripod.
Height Adjustment
Adjusting the height of the tripod can be done by simply flipping the leg
height adjuster locks open, then pulling the legs downward until the desired height
is obtained. Flip the leg locks back down to lock the legs into place. The leg height
adjuster flaps are also equipped with Allen screw heads to fine tune the tension
used to lock the leg in place. You can also utilize the center column to raise the
height of tripod further by loosening the center column lock knob , then pulling the
head upwards until the desired height is achieved. Lock the column into place with
the lock knob to prevent the head from retracting back down.
(Note: When
adjusting height, extend the thicker leg segment first, as they are thicker and
provide greater stability.)
The Quick Release Plate
To remove the quick release plate, first
flip the silver safety lock (A) to unlock the
plate. Next, flip the quick release plate lever
(B) to allow the plate to pop up and release.
To attach the camera to the quick
release plate, hold camera securely in one
hand, and locate the 1/4” screw hole on
bottom of your camera. Secure the screw of
the quick release plate on the camera by
turning it clockwise.
To insert the quick release plate, insert
the plate into the base cut out near the bubble