OPERATION
1.
Connect the power cable to a power socket that is located in a safe,dry area.
2.
The heating power level can be set by pulling the power switch (pull line near the
heating head): level 0, level 1 (750 W), level 2 (1500 W).
3.
Although the heater is shower proof, do not use when raining or in wet conditions.
4.
Always disconnect the power cable from the electrical supply, when the heater is not
in use.
MAINTENANCE AND CLEANING
Attention! Careful and regular maintenance of Infrared Heater is required to attain
a long and efficient operation of your appliance.
1.
Check the cleanliness of the Reflector and IR-Filament at least once a month.
If necessary, apply cleaning and maintenance instructions.
2.
The number of checks may be increased considering the amount of dust
in the environment.
3.
Check the deformation of the Reflector, Wire and Frame visually while cleaning
the appliance. In case of any deformation, consult a qualified technician.
4.
Check the power cable and plug visually while cleaning the appliance. In case
of any deformation, consult a qualified technician.
5.
It is recommended to change the reflector every 2 years for more efficient operation.
CLEANING
Attention!
Always un-plug the heater from the outlet. Allow it to cool down before cleaning.
Clean the outside of the heater by wiping with a dry or slightly wet cloth and buff with a dry cloth.
Do not use any detergents or abrasives and do not allow any water to enter the heater.
Do not submerge in water!
Regular and careful cleaning helps your heater to operate efficiently for many years.
1.
Unplug your power cable for your safety before cleaning your appliance.
2.
Take out the front grid wire through the inlets on the frame using a slotted screwdriver.
3.
The reflector and filament must be cleaned with a soft cloth, a smooth brush
or cool or dry air. The cloth may be damp but never too wet and the cleaner should
not include any chemicals.
4.
Refrain from using cleaning materials likely to damage the reflector (cleanser etc.).
5.
Reinsert the wire grid using a slotted screwdriver.
FAILURES
If any damage is disclosed after purchase, contact the seller.
Follow the rules in this manual.
Do not modify the product.
When the device does not work, unplug it. Check if there is power in the socket the device
is connected to.
If power was not disrupted, do not attempt to repair the device on your own. Contact
manufacturer's authorized service centre.