Rauch QUANTRON-A, Инструкция по эксплуатации

Страница: 29 / 120

Attachment and installation
23
3
3.3 Connecting the control unit
Depending on the equipment, there are different methods of connecting the
control unit to the fertiliser spreader.

The schematic overviews for the connection to the tractor can be found on
Page 24 .

The schematic overviews for the connection to the machine can be found on
Page 27 .
Carry out the work steps in the following order:

Select a suitable position in the tractor cab (within the driver's field of
vision ) where you want to fasten the control unit.

Fasten the control unit with the mounting bracket in the tractor cab.

Connect the control unit to the 7 pin socket or to the forward speed sensor
(depending on configuration).

Connect the control unit to the actuators of the machine with the 39-pin
machine cable.

Connect the control unit to the power supply from the tractor using the 3-pin
plug connector.
NOTICE
After the QUANTRON-A control unit has been switched on, the display shows
the machine number for a short time.
NOTICE
Note the machine number
The QUANTRON-A control unit is factory-calibrated for the fertiliser spreader
with which it has been delivered.
Connect the control unit only to the corresponding fertiliser spreader.