Rauch AXMAT DUO, Инструкция по эксплуатации

Страница: 36 / 44

Operating the AXMAT system 4
32
4.4 Operating the AXMAT function in spreading operation
Prerequisites:

The AXMAT function is enabled. See 4.1: Preparing for calibration, page 18 .

The AXMAT function is activated. See 3.4.1: Activating the AXMAT- function,
page 16 .

The AXMAT function is calibrated. See 4.2: AXMAT calibration, page 24 .
1. Press Spreading disc start .
 The spreading discs start.
2. Press Start/Stop .
 The metering slides open.
 The AXMAT function automatically regulates the drop point during
spreading operation.
Figure 4.12: Regulating the drop point during spreading operation
[1] Active fertiliser chart
[2] Drop point value, right spreading side
[3] Drop point value, left spreading side
Notes:

In boundary spreading mode or with section control on a single side, the
AXMAT function is deactivated for the side operating with application rate
reduction.

The AXMAT function is reactivated at both sides once you return to the
normal spreading mode.
NOTICE
The AXMAT function regulates the drop point in steps of 0.1 during spreading
operation.
2
3
1