Rauch AXMAT DUO, Инструкция по эксплуатации

Страница: 28 / 44

Operating the AXMAT system 4
24
4.2 AXMAT calibration
Perform calibration of the AXMAT function under the following conditions:

You are using the AXMAT special equipment for the first time.

You have entered new settings in the Fertiliser settings menu:
- Fertiliser type
- Spreading disc type
- Disc speed
- Working width

The desired application rate has changed greatly.
1. Call up the Main menu > Fertiliser settings menu.
2. Call up the AXMAT Calibration menu entry.
3. Determine the position for the drop point using the fertiliser chart.
4. Enter the determined value in the input field.
5. Press OK .
6. Press Spreading disc start .
7. Press Start/Stop .
Figure 4.7: Performing AXMAT calibration
8. Perform test spreading over the positioned collecting vessels.
See
4.1.3: Performing a spreading test at a working width of 24 m, page 20 .
 Calibration starts after 6 seconds.
 The display shows the progress bar.
Calibration and the spreading operation must be performed simultaneously.