Rauch Axent Isobus, Инструкция по эксплуатации

Страница: 15 / 74

Layout and function
9
2
2.2.5 Stop switch
By pressing the stop switch, all connected devices are set to a safe condition.

For unlocking the stop switch, turn it in the direction of the arrow until the
switch pops out again.
 The stop switch is unlocked.
Figure 2.4: Stop switch at the CCI 100
Case 1 - Spreading operation
Pressing the stop switch during spreading operation:
- the pre-metering slides are stopped.
- the conveyor belt is stopped.
- the comb roller is stopped.
- the hopper cover is stopped.
Case 2 - No spreading operation (example: calibration/fast emptying)
If no spreading operation is active, all functions are stopped and the metering
slides remain open.
A warning message is displayed as soon as the stop switch is actuated.
1. Rectify the cause of the fault.
2. Unlock the stop switch

Another alarm message warning against possible unexpected move-
ments is displayed.
3. Press the ACK foil key
n
CAUTION
Risk of injury from rotating spreading discs!
The spreading discs are not stopped.
 Switch off the PTO shaft of the tractor.
 Ensure that nobody is in the hazard zone.
!