900 MHz Base Station Installation:
1. Set base station in the planned location.
2. Assemble the antenna to the magnetic base.
3. Attach the antenna to the base station at the connection marked ANT.
4. Attach the supplied cable into the TEL port of the base station and connect to an analog phone jack.
5. Plug in the transformer into the wall and connect to the base station.
Programming the Phone:
On-Site:
Step 1. Open up Nema enclosure to expose keypad
Step 2. Begin Program mode
A. Press
Enter
Step 3. Program Emergency Numbers
A. Press
1, Enter,
(phone number),
Stop
Note: Press
2-5
in step 2A for Emergency numbers 2-5
as needed
Step 4. If Ring Down
(No dial tone) (Skip Step 3 above)
A. Press
1, Enter, Pause, Stop
B. Press
9, Enter, 0
Step 5. Program Call Tracker Message
A. To turn on message Press
1, 3, Enter, 2
B. Press
6
,
Record
(speak message)
Stop
(to replay message Press
6, Play
)
C. For no message Press
1, 3, Enter, 0
Step 6. To exit program mode
A. Press
Stop
for 3 seconds
pg. 4
C O M M U N I C A T I O N S
E M E R G E N C Y
866-850-8854 www.rathsecurity.com
You can program the phone on-site or program remotely. If you change the emergency number
being called, you can do it remotely without going to the call station.
