EN
11
If the blade is no more able to cut (even after repeating
the sharpening operation several times) it is necessary to
replace it. To carry out this operation, use wrench “1”
and drift “3” locking the blade (shown in picture 15).
To replace the blade, proceed as follows:
1) Use some protective gloves in compliance with
Italian Legislative Decree 81/08;
2) Remove the mobile front safety protection “B” (see
picture 16) by unscrewing pin “C” and removing
the washer “D” as shown in picture 17.
Remove the fixed rear safety protection “A” (see
picture 16) by unscrewing the two cross screws
“E” by means of a screwdriver (not supplied by
the manufacturer) as shown in picture 18.
3) Insert drift “3” (see picture 15) into hole “F”, so as
to lock the blade (the hole on the blade must
correspond to the one on the structure).
4) Use wrench “1” to unscrew nut “G” and remove
blade “H” (see picture 18).
5) Replace the worn blade with the new one “2”,
being careful to center the blade on the shaft, in
the correct position, and remember to assemble it,
so that the Rasor writing can be seen by the
operator.
6) Assemble all the components again and carry out
the sharpening.
15. BLADE REPLACEMENT
1
15
16
A
B
3
2
17
18
D
C
E
F
G
1
H
Содержание SW12SSX
Страница 1: ...CUTTING UNIT USE MANUAL SW12 SSX...
