RASOR FP861, Руководство пользователя

Страница: 11 / 15

EN
11
11
12
E
F
G
10
1
2
1
3
C
B
A
D
14. BLADE REPLACEMENT
If the blade is no more able to cut (even after repeating
the sharpening operation several times) it is necessary to
replace it. In order to carry out this operation, use butterfly
key “1” and drift “3” locking the blade (shown in picture
11).
In order to replace the blade, proceed as follows:
1) Use some protective gloves in compliance with the
Local Law of the Country where the machine is to
be used (use of personal protection devices);
2) Remove fixed safety protection “A” and the movable
front safety protection “B”, by unscrewing respectively
the cross screw “C” and the slotted screw “D” by
means of a screwdriver (not supplied by the
manufacturer), as shown in picture 11.
3) Insert drift “3” (see picture 10) in hole “E” in order
to lock the blade (the hole in the blade must
correspond to the hole in the structure).
4) Use butterfly key “1” in order to unscrew nut “F”
and remove blade “G” (see picture 12).
5) Replace the worn blade with the new one “2”, being
careful to center the blade on the shaft, in the correct
position, and remember to assemble it with its sharp
side (the one with the writing Rasor) positioned
towards the external side of the pneumatic scissors.
6) Assemble all the components again and carry out
some cutting and sharpening tests.