RASOR FP70, Руководство пользователя

Страница: 10 / 15

10
EN
12. SHARPENER ADJUSTMENT
After using the machine for some hours without interruption,
or if the machine cutting capacity is reduced, it is necessary to
sharpen the blade.
To carry out this operation, start the blade and press sharpening
push button “1” (as shown in picture 8), for 3-4 seconds.
Repeat this operation 2-3 times.
11. AIR PRESSURE GAUGE (OPTION)
13. LUBRICATION
Every 3-4 working days, it is necessary to lubricate the
gear pair. In order to carry out this operation, remove
protective plug “A” located on the head of the
pneumatic scissors and fill it with the grease supplied.
Screw plug “A” again a few turns. Screw plug “A” a
few turns every 2-3 working days (see picture 9) when
the machine is used without interruption.
Fill the plug again, once it has been tightened.
The blade must never be dirty with grease or oil.
WARNING
7
The pneumatic scissors must be necessarily fed with
lubricated air with a pressure of 4-6 bar.
Rasor
®
offers, as option, a reduction unit filter with a
pressure gauge already calibrated with the quantity
of oil to be delivered.
The unit shown in picture 7 is made up of:
1 - pressure reducer;
2 - valve to drain the condensate;
3 - drip-feed oiler unit;
4 - oil tank;
5 - pressure gauge;
6 - condensate tank;
7 - pipe fitting to connect the quick connection to
the network;
8 - pipe fitting to connect the quick connection to the scissor.
For the use and maintenance read the instruction sheet supplied with the filter.
5
1
2
3
4
6
7
8
The sharpening push button can be only pressed if the front mobile protection is completely
lowered.
WARNING
1
8
9
A