REV. 1/25/08
Page 4 of 7
INSTALLATION INSTRUCTIONS
WARNING
DO NOT CONNECT REMOTE RECEIVER DIRECTLY TO 110-120VAC POWER. THIS WILL BURN
OUT THE RECEIVER. FOLLOW INSTRUCTIONS FROM MANUFACTURER OF GAS VALVE FOR
CORRECT WIRING PROCEDURES. IMPROPER INSTALLATION OF ELECTRIC COMPONENTS
CAN CAUSE DAMAGE TO GAS VALVE AND REMOTE RECEIVER. DAMAGE CAUSED BY
IMPROPER INSTALLATION WILL NOT BE COVERED BY WARRANTY.
INSTALLATION
The remote receiver can be mounted on or near the fireplace hearth. PROTECTION FROM EXTREME HEAT IS VERY IMPORTANT.
Like any piece of electronic equipment, the remote receiver should be kept away from temperatures exceeding 130º F inside the
receiver case. Battery life is also significantly shortened if batteries are exposed to high temperatures.
NOTE: Installation of the receiver in the optional Ceramic Log House (Item# RH2)) is highly recommended.
HEARTH MOUNT
The remote receiver can be placed on the fireplace hearth or under the fireplace, behind
the control access panel. Position where the ambient temperature inside the receiver
case does not exceed 130º F.
NOTE: Black Button is used on Hearth Mount Applications.
WIRING INSTRUCTIONS
Make sure the remote receiver switch is in the OFF position. For best results it is recommended that 18 gauge stranded wires should
be used to make connections and should be no longer than 20 ft.
This THR-2R-1 remote receiver is to be connected to a manual valve with a latching ON/OFF solenoid.
Connect two 18 gauge stranded or solid wires from the remote receiver terminals to the latching solenoid. (See figure to the right)
IMPORTANT NOTE:
Operation of this control is dependent on which wire is attached to which terminal. If operation of control does
not correspond to operating buttons on transmitter, reverse wire installation at the receiver or at the control.
NOTE
: Up to 6.3 VDC of power is provided at the receiver terminal.
STV-LS
Solenoid
1/4” Male
Connectors
Black Wire
Red Wire
STV-10
Valve
Wire terminals
Remote Receiver
Receiver
Slide
Button
LEARN
ADJ.
REMOTE
OFF
ON
Remote Receiver
Receiver
Slide
Button
PULSE MODE
Terminals
RED Wire
1/4” Female
Terminal
BLACK Wire
1/4” Female
Terminal
(Back of Receiver)
BLACK Wire
1/4” Female
Terminal
RED Wire
1/4” Female
Terminal
LEARN
ADJ.
Part # BPR-3
REMOTE
OFF
ON
f i r e - p a r t s . c o m
