10
View from behind burner
1.
FRONT LOGS:
Align the
Front
Log Guide Grooves
(Figures 4 and 5) with right and left ends of the
Front
Burner
(Figures 4 and 5) and position the
Front Logs
between the
Burner
and the
Grate Teeth
as shown in Figure 8C. The
Front log has a small notch on the right and left sides to help align the log with Grate Teeth. (18” Log set used below
for example)
2.
PAN MEDIUM:
With Both
Front Logs
on the Grate as shown in Figure 8, below), pull the
Ember Magic
apart into
loose, thin pieces
(Figure 6) and drape them over the
Ember Lifter
(Figure 7) completely covering the
Burners.
ember material
should be no more than one to two pieces of ember material in depth.
To ensure proper ignition
and combustion and to enhance ember performance gently loosen & lift Ember Material with a screw driver after
approximately five minutes of burn time.
STEP THREE: LOG PLACEMENT (ALL MODELS)
●
NOTE:
Thinner, less densely packed
pieces of Ember Material will enhance the overall glowing ember effect, e.g., the
looser the pieces, the better the glowing ember effect as in Figure 6 above!
WARNING:
Excessive amounts of Ember Material or Ember Material which is too tightly packed, or exposed ports on Front
or Middle burner can result in decreased combustion performance and elevated levels of carbon monoxide.
Side View of burner
Ember Lifter
Guide Groove
View from behind burner
Notch
FIGURE 4
FIGURE 8
Guide Groove
Grate Teeth
FIGURE 5 FIGURE
6 FIGURE
7
