Rasilient PixelStor 5000, Руководство пользователя

Страница: 56 / 161

Hardware Installation
PixelStor 5000 User Manual
Rev. 1, May 2013 4-19
7. This will start the CLI setup wizard.
Figure 4-1 CLI Setup Wizard
8. Once launched, the wizard will walk your through the network configuration. The default
values are in the brackets. You can hit your enter key to accept the default value or type
in the private network information you received from your network administrator to
If you have not done so already, consult with your network administrator for IP
addresses that you can use to set up
PixelStor 5000 on your network
This wizard will only run automatically when you log in from the serial terminal as
“root”. It will NOT run when you login using telnet or log in as a non-root user.
Once the network is configured, the wizard will not run automatically again.
However, you can run the wizard manually by issuing the command 'dasetup' from
the CLI (See Appendix B
– Using the Command Line Interface for more information)