Rasha Professional A/S 1130 Palmyrita Ave. Ste 320, Riverside CA, 92507
|
951-654-3585
|
951-394-8480
rashaprofessional.com
|
8
SETUP
Power Supply
Each
Hex V7 DMX + IR
has an auto-ranging power supply that works with
an input voltage range of 100 to 240 VAC, 50/60 Hz. To determine the
power requirements for each
Hex V7 DMX + IR
refer to the label affixed
to the product. You can also refer to the Technical Specifications chart in
this manual. The listed current rating indicates the maximum current draw
during normal operation. For more information, you may download Sizing
Circuit Breakers from the Rasha website: www.rashaprofessional.com
Always connect this product to a protected circuit with an appropriate
electrical ground to avoid the risk of electrocution or fire. To eliminate
unnecessary wear and improve its lifespan, during periods of non-
use completely disconnect the product from power via breaker or by
unplugging it.
Never connect this product to a rheostat (variable resistor) or dimmer
circuit, even if the rheostat or dimmer channel serves only as a 0 to 100%
switch.
AC Plug
The
Hex V7 DMX + IR
comes with a power input cord terminated with
a Edison power cable. A connector on one end and an Edison plug on
the other end (U.S. market). If the power input cord that came with your
product has no plug, or if you need to change the Edison plug, use the
table below to wire the new plug.
Fuse
Replacement
1. Disconnect this product from the power outlet.
2. Using a flat-head screwdriver, lift the fuse holder cap from the housing.
3. Remove the blown fuse and replace with a another fuse of the same
type and rating (T 5 A).
4. press the fuse holder cap back in place and reconnect power.
Make sure to disconnect the product’s power cord before replacing a
blown fuse. Always replace the blown fuse with another of the same type
and rating
Power Linking
You can link 20 Fixtures @ 110V and 30 fixtures @ 220V.
DMX
Personalities
• The
Hex V7 DMX + IR
uses a 3- or 5-pin DMX data connection for the 6
or 11 channel DMX personalities.
• Refer to the Introduction chapter for a brief description of each DMX
personality.
• Refer to the Operation chapter to learn how to configure the
Hex V7 DMX
+ IR
to work in these personalities.
• The DMX Values section provides you with detailed information regarding
the DMX personalities
Connection
Wire (U.S.)
Wire (Europe)
Screw Color
AC Live
Black
Brown
Yellow or Brass
AC Neutral
White
Blue
Silver
AC Ground
Green/Yellow
Green/Yellow
Green
If you are not familiar with or need more information about DMX standards, Master/Slave connectivity, or
the DMX cables needed to link this product to a DMX controller, download the DMX Handbook from the
Rasha website: www.rashaprofessional.com
