Raritan PX3TS, Руководство пользователя

Страница: 691 / 842

667
You can accomplish part or all of the following tasks simultaneously by
plugging a USB flash drive which contains one or several special
configuration files into the PX3TS.

Configuration changes

Firmware upgrade

Downloading diagnostic data
Tip: You can also accomplish the same tasks via the TFTP server in a
DHCP network. See
Bulk Configuration or Firmware Upgrade via
DHCP/TFTP (on page 679).
In This Chapter
System and USB Requirements.............................................................. 666
Configuration Files .................................................................................. 667
Firmware Upgrade via USB..................................................................... 677
System and USB Requirements
You must satisfy ALL of the following requirements prior to using a USB
flash drive to perform device configuration and/or firmware upgrade.
PX3TS system requirements:

There is at least one USB-A port available on your Raritan device.

Your PX3TS must be version 2.2.13 or later.
Note that the PX3TS interpreted the USB drive's contents using the
firmware which was running when plugging the USB drive, not the
new firmware after firmware upgrade.
USB drive requirements:

The drive contains either a single partition formatted as a Windows
FAT32 filesystem, or NO partition tables (that is, a
superfloppy-formatted drive).

The drive contains a configuration file called
fwupdate.cfg in its root
directory. See
fwupdate.cfg
(on page 668).
Appendix C Configuration or Firmware Upgrade
with a USB Drive