Raritan PX3TS, Руководство пользователя

Страница: 617 / 842

Chapter 8: Using the Command Line Interface
593
Adding an LDAP Server
Adding an LDAP server requires the entry of quite a lot of parameters,
such as the server's IP address, TCP port number, Base DN and so on.
You can repeat the following CLI command to add more than one LDAP
server.
Tip: If any LDAP server's settings are identical to an existing LDAP
server's, you can add it by just copying the existing one, instead of using
the following command. See
Copying an Existing Server's Settings
(on
page 596).
Add a new LDAP server:
config:# authentication ldap add <host> <port> <ldap_type> <security>
<bind_type> <base_DN> <login_name_att> <user_entry_class>
"Optional
Parameters"
Note: "Optional Parameters" refer to one or multiple parameters listed
in the section
Optional Parameters
(on page 593). They are required
only when your server settings need to specify these parameters. For
example, if setting the <bind_type> to "authenticatedBind", then you
must add the parameter "bindDN" to this command.
When the above command is successfully performed, a list of all LDAP
servers, including the newly-added one, will be displayed, which is
similar to the following diagram.
Tip: To verify all settings of a newly-added server, see
Authentication
Settings (on page 488).
Variables:

<host> is the IP address or host name of the LDAP server.

<port> is the port number assigned for communication with the
LDAP server.

<ldap_type> is one of the LDAP server types: openldap or
activeDirectory.
Type Description
openldap
OpenLDAP server