Raritan PX2-1000 SERIES, Руководство пользователя, Страница: 307 / 648

Chapter 6: Using the Web Interface
288
Note: If the desired action cannot be performed on any of the
selected sensors or actuators, that action becomes unavailable.
Deselect the inapplicable ones to perform the action.
3. Click Release.
After a sensor or actuator is removed from management:

The ID number assigned to it is released, and can be automatically
assigned to any newly-detected sensor or actuator if the Auto
Management feature has been enabled. See
Disabling the
Automatic Management Function
(on page 288).

If it is no longer connected to the PX, it disappears from the sensor
list on the Peripheral Devices page.

If it remains connected, it continues to be listed on the Peripheral
Devices page but its state is changed to
unmanaged
. See
States of
Unmanaged Sensors or Actuators
(on page 287).
Disabling the Automatic Management Function
The factory default is to enable the automatic management feature for
environmental sensors and actuators. Therefore, when the total number
of managed sensors and actuators has not reached 32 yet, the PX
automatically brings newly-connected environmental sensors and
actuators under management after detecting them.
When this feature is disabled, the PX no longer automatically manages
any newly-detected environmental sensors and actuators, and therefore
neither ID numbers are assigned nor sensor readings or states are
available for newly-added ones.
To disable the automatic management feature:
1. Click the PDU folder.
Note: The folder is named "my PX" by default. The name can be
customized. See
Naming the PDU (on page 112).
2. Click Setup in the Settings section. The Pdu Setup dialog appears.
3. Deselect the Peripheral Device Auto Management checkbox.
4. Click OK.