Raritan EMX2-111, Руководство пользователя

Страница: 341 / 565

Chapter 8: Using the Command Line Interface
329

<mode> is one of the modes: automatic or static.
Mode Description
automatic The IPv6 configuration mode is set to automatic.
static The IPv6 configuration mode is set to static IP
address.
Setting the IPv6 Preferred Host Name
After selecting DHCP as the IPv6 configuration mode, you can specify the
preferred host name, which is optional. The following is the command:
config:# network ipv6 interface <ETH> preferredHostName <name>
Variables:

<ETH> is one of the network interfaces: ethernet, wireless, bridge or
all. Note that you must choose/configure the bridge interface if your
EMX is set to the bridging mode.
Note: In the bridging mode, only the IP parameters of the BRIDGE
interface function. The IP parameters of the ETHERNET and
WIRELESS interfaces do NOT function.
Interface Description
ethernet Determine the IPv6 preferred host name of the
ETHERNET interface (that is, wired networking).
wireless Determine the IPv6 preferred host name of the
WIRELESS interface (that is, wireless
networking).
bridge Determine the IPv6 preferred host name of the
BRIDGE interface (that is, bridging mode).

<name> is a host name which:

Consists of alphanumeric characters and/or hyphens

Cannot begin or end with a hyphen

Cannot contain more than 63 characters

Cannot contain punctuation marks, spaces, and other symbols