Raptor KPHG2031, Руководство пользователя, Страница: 8 / 22

8
8.1 Switching on and off
- To switch the tool on, set the on/off switch to position I/II/III. Some smoke may be
emitted after switching on; this does not indicate a problem.
- To switch the tool off, adjust the lowest temperature to cool off, then set the on/off
switch to position 0. Let the tool cool down before moving or storing it.
8.2 Temperature setting
Turn ON/OFF switch to I/II/III, depending on temperature you need. Press any of the
adjusting buttons and the heat gun will start to buzz. Now you can increase or decrease
the outlet temperature and air flow gradually by pressing the buttons
8.3 Stripping paint
- Mount an appropriate accessory.
- Set a high air temperature.
- Switch the tool on.
- Direct the hot air onto the paint to be removed.
- When the paint softens, scrape the paint away using a hand scraper.
Do not strip metal window frames, as the heat may be conducted onto the glass
and crack it. When stripping other window frames, use the glass protection
nozzle.
Do not keep the tool directed at one spot too long to prevent igniting the surface.
Avoid collecting paint on the scraper accessory, as it may ignite. If necessary,
carefully remove paint debris from the scraper accessory using a knife.
8.4 Stationary use
This tool can also be used in stationary mode.
- Place the tool onto the workbench.
- Secure the cable to prevent pulling the tool off the workbench.
- Carefully switch the tool on.
Make sure that the nozzle always points away from you and any bystanders.
Make sure not to drop anything into the nozzle.
8.5 Cooling down
The nozzle and accessory become very hot during use. Let them cool down before
attempting to move or store the tool.
- To reduce the cooling time, switch the tool to position I which is at the lowest air
temperature and adjust the air flow to Max. and let it run for a few minutes.
- Switch the tool off and let it cool down for at least 30 minutes.
MAINTENANCE AND CLEANING
ATTENTION! Before performing any work on the equipment, pull the power plug.