3.
Begin installation on driver side. Position
drivers side Front Bracket, Center Bracket
and Rear Bracket as shown along driver side.
Assemble the Load Reaction Studs as follows:
4a.
On the short threaded end of the Load
Reaction Stud, install a M10 Hex Head Nut, a
M10 Flat Washer to the bottom of thread,
then install a Rubber Block tight up against
the M10 Washer and the M10 Hex Head Nut.
(The end of the Stud must be recessed in the
rubber washer approximately 3/16").
4b.
On the long threaded end of the Load
Reaction Stud, install a M10 Flat Washer, a
M10 Lock Washer and a M10 Hex Head Nut to
the bottom of the threads.
NOTE: IF MOUNTING THE RUNNING BOARD
ON A 1500 MODEL TRUCK. YOU MUST
ATTACH L BRACKET TO FRONT BRACKET
IN ORDER TO USE THE LOAD REACTION
STUD.
5.
Remove the factory front, center and rear
cab mount bolts and install the mount brack-
ets and running board per following instruc-
tion.
6.
Install the Brackets to the Cab Mounts as
shown. Hand tighten, until the Load Reaction
Stud and the Running Board has been
installed. When installing on 2015-Current HD,
use 2 spacer washers between factory bush-
ing and mounting bracket.
7.
Attach the load reaction stud assemblies
to the mounting brackets as shown. Insert
the stud from what will be in the inboard or
frame side thru the lowest hole in the bent
flange of the bracket that will allow the
rubber washer to seat firm against the side
wall of the frame. Install a M10 flat washer, a
M10 lock washer and a M10 Hex Head Nut
(Hand tight only)
8.
Attach the Running Board to the Frnot,
Center and Rear Brackets using M5 Button
Head Bolts and M5 Hex Head Nuts.
9.
Repeat these steps for passenger side
installation. When all hardware is in place,
everything must be tightened. See Page 1 for
Torque Specifications.
Driv
er Side
3
2
Rev 2
1301-0151