Rapnas MF-1, Руководство пользователя

Страница: 15 / 46

Connecting speakers
・
Connection method A (Recommendation)
Insert a 4 mm banana clip (not included) to the end of the cable
and insert it into the speaker terminal hole of this instrument.

Attention

How to connect speakers
・
This unit is compatible with speakers that have 4–8Ω nominal
impedance. If speakers with impedance of less than 4 Ω are used,
the protection circuit could operate, causing sound output to
stop. In some cases, this unit or the speakers could be damaged.
・
The red speaker terminals are positive (+) and the black speaker
terminals are negative (-). Generally, the (+) wire of the speaker
cable is marked to distinguish it from the (-) wire of the cable.
Connect the marked wire to the red (+) terminal and the
unmarked wire to the black (-) terminal.
・
If the exposed core wires at the tips of the speaker cables
should touch other cables or terminals, an electrical short might
occur.
・
Never allow speaker cables to cause a short.
・
To prevent hum and noise, avoid bundling the cables together
with the AC power cord or other cables.
・
Connection method B
Remove about one centimeter of insulation from the end of the
speaker cable and twist the core wires well.
Turn the terminal cap counterclockwise to loosen it.
Insert the wire into the hole in the terminal post and turn the
terminal cap clockwise to securely connect it.
Banana Plug
Diameter 4mm
Left Speaker Right Speaker