Rapid ABS 200 A-PKW, Быстрый старт

Страница: 11 / 12

8.1 Bleed pipe system after changing barrel
8.1.1 Change barrel and reconnect any pipe.
8.1.2 Open second hole of barrel (A).
8.1.3 Disconnect delivery hose from automatic nozzle (B)
and insert deliveryhose into second hole of barrel (A).
8.1.4 Switch on pump (C) and run pump until suction and
delivery hose are filled.
8.1.5 Switch off pump (C) and reconnect delivery hose (B)
to automatic nozzle (B).
9. Disposal
In the event of maintenance or demolition of the machine, do not disperse contaminated parts into
the environment.
Refer to local regulations for their proper disposal.
10. Liability and Guarantee
10.1 In case of insufficient maintenance, faults on operation, use of not adequate spare parts
or attachments all liabilities and rights of claim under guarantee are void.
10.2 The manufacturer is not liable for improper use of the container or ignoring the safety
instructions.
10.3 Technical modifications are subject to change without announcement.
8. Maintenance and trouble shooting
Problem Possible cause Correct iv act ion
low or no ow rate low level in the suction tank rell the tank
filter clogged clean the filter
excessive suction pressure lower the pump with respect to the
level of the tank or increase the cross-
section of the tubing
high loss of head in the delivery
circuit (working with the by-pass
open) use shorter tubing or of greater
diameter
air entering the pump or suction
tubing check the seals of the connections
a narrow in the suction tubing use tubing suitable for working under
suction pressure
the suction tubing is resting on the
bottom of the tank raise the tubing
Nozzle clogged Clean nozzle with warm water
increase pump noise cavitation occuring reduce suction pressure
irrregular functioning of the by-
pass dispense fluid until air is purged from
the by-pass system
Leaks inside system
Immediately switch off pump
and/or disconnect from power Immediately switch off pump and/or
disconnect from power
A
B
C
11
+49 (6158) 92980-0