Operating Instructions D50+ | P50+ | SHERAprint 50
45
│
96
Rapid Shape GmbH
│
DOCR000438
7.6.3
Inserting the Knife Drip Guard & the Knife
CAUTION!
Risk of injury due to sharp objects!
The knife on the separation unit has a sharp edge that
can cause slight hand injuries through direct contact.
–
The edge should never be touched directly.
Only hold the knife by the knurled nuts and with
the blade away from your body.
Proceed as follows to insert the knife drip guard and the knife:
1.
Prerequisite: A build platform has been inserted.
→
Chapter 7.6.2
2.
Pick up the knife drip guard.
3.
Insert the knife drip guard on the left and right with the retaining
collars facing downwards into the bracket provided on the
machine. The chamfered edge must point into the machine.
4.
Make sure that the knife holder is in reference position:
Main menu >
«
Manual Mode
»
>
«
ASM Manual Mode
»
.
5.
Read the warning shown on the display. Confirm this by setting
the confirm checkmark to the left of the
«
Confirm
»
button.
Then press the
«
Confirm
»
button to enter ASM manual mode.
(see fig. below)
Figure 18: Manual mode,
”ASM Manual Mode“
warning notice
6.
Press the
«
Reference
»
button to move the knife holder to
reference position. (see fig. below)
7.
Then return to the main menu: Press the
«
Home
»
button.
8.
Now grasp the knife by the black knurled thumb nuts. Take note
of the side markings (left/right) on the knife carrier plate while
doing so.
9.
Place the knife in the holder on the machine and press it down
until it is fully engaged.
10.
Insert the knife protection device back into the machine and
push it back as far as it will go to close the device.
11.
Continue with inserting the material reservoir.
→
Chapter 7.6.4