Rapid Engineering CTHN-40, Руководство по установке и эксплуатации

Страница: 47 / 100

SECTION 9: M
ULTIBURNER
H
EATER
I
NSTALLATION
41 of 91
Step 9.9 Coupling and Tube Assembly
Step 9.9.1 Coupling and Tube Assembly (Continued)
Tube
Tube
Orient coupling so that
the impact block is in the
2:00 or 10:00 o’clock
positions.
Closed
Open
Tab
3" (8 cm) to
4" (10 cm)
Slide Bar/Coupling Lock
Coupling
Wide End
Coupling
Tube
Slide Bar/Coupling Lock
A
Close co u pling
w ith tab.
B
Start slide bar/co u pling lock
onto co u pling.
C
Insert t u bes into co u pling.
D
Tighten co u pling to join t u bes.
Description Part Number
Co u pling 01329600
Slide Bar/Co u pling Lock 01329700
T u be 91409XXX
Incorrect slide bar
position
Correct slide bar
dimensions
± 2" (5 cm)
Drive slide bar until tight.
End of slide bar should be
within tolerance listed below.
• Repeat Step 9.9 on Page 41 , A - D until all tubes are assembled. See Page 42, Step 9.9.2 .
NOTE: If coupling is not tight, loss of vacuum can occur.
Tighten slide bar as shown below.