Rapid Electronics KG888, Руководство по установке

Страница: 21 / 24

9
Optional Auxiliary Plug-In Dual Zone Sensor
4-pin white plug
Plug the auxiliary dual stage sensor's connector into the alarm's 4-pin white plug; this
port supplies 12 volts (RED wire), ground (BLACK wire), 1
st
stage trigger (GREEN wire),
and 2
nd
stage trigger (BLUE wire).
Plug-In Red LED Status Indicator
2-pin red plug
Mount the Red LED Status Light in a location where the driver can see it easily, and
where it can be seen from outsides. Locate a suitable location, drill 1/4" hole, pull wires
through and push LED, then connect plug-in LED to 2 pin red connector.
WHITE wire -
20gauge
Single Bullet wire Tach Sense wire
This TACH SENSE wire is a spare wire for few special cars, which cannot detect the
engine start signal from power line (ignition sense), such as, it can’t start the engine
successfully. Connect White wire to charger (+) or starter solenoid (+) of vehicle.
BLACK loop wire Start Mode Selector
There are two modes for remote engine starting –
once mode
and
auto mode
, selected
by this black loop wire. Refer to following chart:
No. Black loop wire’s situation Start mode
1. Cut Once mode
2. Not cut Auto mode
WHITE loop wire Door Lock Active Time Selector
This white loop wire can select the active time for central lock. See the following chart:
No. White loop wire’s situation Door lock active time
1. Cut 3.5 seconds
2. Not cut 0.5 second