SAB-QS Quick Start
November 9, 2000
Rapid Controls Inc.
Box 8390
§
Rapid City, SD
§
57709
Phone: 605-348-7688
§
Fax: 605-341-5496
http://www.rapidcontrols.com/
§
email: [email protected]
SAB-QS Quick Start
This document aims to provide a systematic setup procedure to enable you to setup and use your SAB-QS
as easily as possible. This guide will concentrate on connections and basic setup. More information is
available for advanced setup, refer to the SAB-QS manual. If you do not have a TDD manual, call Rapid
Controls or visit the Rapid Controls website, www.rapidcontrols.com.
3
X7
JP1
1
2
3
4
5
6
7
8
9
10
X6
X5
X3
QUADRATURE OUT
TRANSDUCERS
X1
JP3
1
2
3
4
5
6
7
8
9
10
11
12
13
14
1
X4
1
JP4
1
2
3
4
3
1
X2
3
1
2
SAB-QS
3
1
1
POWER IN
3
CO
MMUNICATIONS
STROBE AND STATUS
JP2
1
2
3
4
5
6
7
8
9
10
11
12
13
14
3
3
1
Figure 1: SAB-QS Connector and Jumper Placement
1.
Power Connection (Connector JP4)
Power input to JP4 provides power to the board and the transducers. Refer to the transducer
requirements before choosing a power source for the SAB-QS. The following pins must be connected:
Pin 1 is connected to 24VDC or +15VDC depending on the requirements of the
transducer.
Pin 2 is connected to ground.
Pin 3 is connected to –15VDC if required by the transducer. Otherwise, no connection is made.
