Ransomes MP655, Инструкция по безопасности, эксплуатации и техническому обслуживанию/Список запасных частей

Страница: 35 / 116

en-35
5 CONTROLS
5.2.Z.35 WARNING SLOPE ANGLE 16° _____________________________________
During work if the machine is driven on a slope of 16º the screen will display this
warning. This over rides all other information, and will continue until the machine has
been driven to an area with a slope of less than 16º
Press the button below the

to confirm the fault.
5.2.Z.36 WARNING SLOPE ANGLE 19° _____________________________________
If the slope angle reaches 19º the screen will display this warning which indicates that
the cutting unit arms are locked in the current position and will continue to run but
cannot be re engaged, until operating below 19°. An audible warning will be sounded,
the warning will sound four times every 4 seconds and the red LED’s will flash four times
every 4 seconds. This will continue until the machine has been driven to an area with a
slope of less than 19º.
Press the button below the

to confirm the fault.
5.2.Z.37 WARNING SLOPE ANGLE 25° _____________________________________
If the slope angle reaches 25º the screen will display this warning indicating that
at 25
º
the front and centre cutting units will be lifted and held above the ground to improve
the stability and all cutting units will stop rotation.
An audible warning will be given, the
buzzer will sound four times every 4 seconds and the red LED’s will flash four times
every 4 seconds. This will continue until the machine has been driven to an area with a
slope of less than 19º.
Press the button below the

to confirm the fault.
0°
Slopes > = 16°
in either x or y
0°
Slopes > = 18°
in either x or y
0°
Slopes > = 22°
in either x or y