Ransomes Matador 71, Инструкция по безопасности и эксплуатации/Руководство по техническому обслуживанию и запасным частям

Страница: 27 / 80

GB-25
RANSOMES MATADOR 71 series: BN/CF
SAFETY, OPERATORS, MAINTENANCE AND PARTS MANUAL
8.11 MAIN CLUTCH ADJUSTMENT
1. Undo clutch cover fixing bolts. The cover
can then removed leaving the clutch
uncovered.
2. Using a feeler gauge (B Fig. 8.12) adjust
'A' (Fig. 8.12) until the gap is between
0.38mm (0.0014") and 0.50mm (0.0020").
3. Replace the cover and tighten screws.
Important:
After any adjustment of the main drive clutch the
system check outlined in section 7.2 should be
carried out to ensure the correct operation of the
Operator Presence System.
8 ADJUSTMENTS
8.10 HANDLE ADJUSTMENT
The height of the handle can be adjusted two ways
to suit the operator :
Where the tubes are attached to the side frames
(A Fig. 8.10) and where the handlebars are attached
to the lower handle tube (B Fig. 8.10)
To adjust the height:
1. Slacken the clamp bolts (A Fig. 8.10b) to
adjust the angle on the handlebars
Retighten the bolts.
2. For vertical handlebar adjustment remove
the coach bolt from the handlebars, then
replace in appropriate slot, (A Fig. 8.10a)
retighten bolt.
Fig. 8.10
Fig. 8.12