Ransomes Magna Mk13 LJBA015, Руководство по сборке и эксплуатации

Страница: 24 / 30

en-24
RANSOMES GANG MOWERS
SPORTCUTTER Mk11, MAGNA Mk13
SAFETY AND OPERATORS MANUAL
8.3 OPERATING THE GANG MOWERS
1. (Fig. 23). Engage the cutting unit drive by
pulling out and turning the gear selectors
(A) on each side of the cutting unit to a
vertical position and ensure that the cross
pin (B) is located in the vertical groove.
Both selectors must be in drive otherwise
overloading and also wheel slip will be
caused.
2. The correct towing speed is dependent
on ground conditions.
Average conditions 6—8 kph (4—5 mph).
Good, relatively smooth ground
conditions 9—11 kph (6—7 mph).
Speeds of up to 16 kph (10 mph) can be
used where ground conditions permit.
3. If the rear rolls bounce slow down. It is a
sign that you are going too fast.
4. The speed of the machine should be fast
enough to give a good grass throw from
the rear of the unit. This will ensure even
distribution of the cut grass behind the
machine and give a good appear ance
and also prevent grass being carried
round by the cutting cylinder and choking
it.
Fig 23
Fig 24
8 OPERATION
The daily inspection should be performed
only when the engine is off and all f uids
are cold. Lower implements to the ground,
engage parking brake, stop engine and
remove ignition key.
CAUTION
8.2 DAILY INSPECTION
1. Perform a visual inspection of the entire unit, look for signs of wear, loose hardwear and missing or
damaged components. Check for fuel and oil leaks to ensure connections are tight and hoses and
tubes are in good condition.
2. Make sure all cutting units are adjusted to the same height of cut.
3. Check all tyres for proper in fl ation.
5. Avoid rapid acceleration or violent
engagement of the tractor clutch. Pull
away gently to avoid shocks to the
transmission, this will help consid erably
towards obtaining long life and good ser-
vice from your machine.