Ransomes 942236, Инструкция по безопасности и эксплуатации

Страница: 34 / 72

GB-32
ZT 220D
Series
BELT REPLACEMENT
CUTTERDECK BELT
1. Set the cutterdeck in the lowest height-of-cut
position.
2. Remove the engine-cutterdeck belt from the
deck idlers and pulley (see engine-cutterdeck
belt replacement). Push it aside but don't
remove it from the machine.
3. Run the cutterdeck belt off the idler as shown.
Remove it from the deck.
4. Install the new belt by performing these steps in
reverse order. Take care to get the new belt on
the correct side of the belt guides.
5. Re-install engine-cutterdeck belt (see engine-
cutterdeck belt replacement).
PUMP-DRIVE BELT
1. Remove discharge deflector under engine deck.
2. Remove engine-cutterdeck belt (see engine-
cutterdeck belt replacement).
3. Attach an extension to a 3/8" drive ratchet. Insert
the ratchet extension in the square hole of the
pump drive idler arm. Use the ratchet handle to
rotate it enough to remove the pump drive belt.
4. Install a new pump drive belt in the same
manner as it was removed.
5. Reinstall engine-cutterdeck belt (see engine-
cutterdeck belt replacement).
6. Reinstall discharge deflector under engine deck.