Vector Solo Waterborne Applicators - Installation
14
Ransburg
Air Hose
For proper safe function of the applica-
tor, the 79727-XX Air Hose must be used
(either standard or quick disconnect style).
W A R N I N G
!
Fluid Hose Recommendation
Ransburg recommends using either a 3/16" ID
(79524) or an 1/4" ID (79525) Fluid Hose As-
sembly. This assembly is made to specifically fit
the applicator. This hose is available from your
authorized Ransburg distributor. Available hose
lengths are listed in "Accessories" in the "Parts
Identification" section of this manual.
Any user installed fluid hose used must
be rated for 6.9 bar (100 psig) working pres-
sure minimum.
C A U T I O N
!
WATERBORNE HOSE
FITTING INSTALLATION
For 79901 RS90 Solo - Waterborne: Ransburg
supplies the waterborne fluid hose factory pre-as-
sembled to the applicator unit. Standard hose
lengths are 10m, 15m, 20m, and 30m. To modify
the hose length, use the following procedures.
All adjustments must be made at the supply end
of the system.
1. Remove the male connector and swivel fitting
from the end of the fluid hose by turning the nut
of the male connector counter-clockwise while
holding its main body.
2. Remove the male connector nut from the fluid
hose.
3. Determine the hose length that is needed and
cut the hose off squarely.
4. Carefully score the outer jacket linearly and then
radially approximately 45.7 cm (18-inches) back
from the cut end. Split the outer jacket along the
linear score mark and peel it away from the inner
sheath. Then remove the jacket completely by
tearing along the radial score mark.
Special care must be taken when re-
moving the sheathing from the fluid hose.
Make sure all tools are very sharp and only
score the surface of the sheath. Inserting
the knife too deep can score the surface of
the core material and lead to pin-holing and
failure of the hose.
W A R N I N G
!
5. Lightly score the inner sheath linearly and then
radially 1-inch from the outer jacket. Split the in-
ner sheath along the linear score mark and peel
it away from the core fluid hose. Then remove
the sheath completely by tearing along the radial
score mark.
6. Roll the inner sheath back over itself until it
touches the outer jacket.
7. Cut approximately 1/4-inch of inner sheath off.
AH-08-03.6
