TF2049101-KK-01 Eng Page 5 of 20 20180720 V.1
WARNING
Installation Safety Precautions.
Use appliance only with LP (propane) gas and the regulator/ valve assembly
supplied.
Installation must conform with local codes or, in the absence of local codes, with
the
National Fuel Gas Code, ANSI Z223.1/NFPA 54
,
Storage and Handling of
Liquefied Petroleum Gases, ANSI/NFPA 58;
or
Natural Gas and Propane
Installation Code
,
CSA B1 49.1
This appliance shall be used only outdoors, and shall not be used in a building,
garage or any other enclosed area.
Use appliance at least 10 ft. from any
wall or surface. Maintain 10 ft. clearance
to objects that can catch fire or source
of ignition such as pilot lights on water
heaters, live electrical appliances, etc.
Never use under balconies made of
wood or ANY overhead construction.
Apartment Dwellers: Check with
management to learn the requirements
and fire codes for using an LP Gas
appliance at an apartment. If allowed,
use outside on the ground floor with a
ten (10) foot clearance from walls or
rails.
Before opening LP tank valve, check the
coupling nut for tightness. When
appliance is not in use, turn off control
knob and LP tank valve.
Never move appliance while in operation or still hot.
If you notice grease or other hot material dripping from appliance onto valve, hose
or regulator, turn off gas supply at once. Determine the cause, correct, clean and
inspect valve, hose and regulator before continuing. Perform a leak test.
The regulator may make a humming or whistling noise during operation. This will
not affect safety or use of appliance.
Clean and inspect the Regulator hose assembly and before each use of the
appliance. If there is evidence of abrasion, wear, cuts or leaks, the hose must be
replaced prior to the appliance being put into operation.
