GR2039201-MM-00-English
P
21
20130829-V1
4. Remove the Cooking Grids, Heat Dispenser Bar and Grease Trays from your grill.
5. Remove the Cotter Pin from the rear of each Burner.
6. Carefully lift each Burner up and away from the Gas Valve Orifice.
7. Check and clean burner/ venture tubes for insects and insect nests. A clogged tube can lead
to a fire beneath the grill.
8. Refer to
Figure 1
and perform one of these three cleaning methods:
METHOD 1: Bend a stiff wire or wire coat hanger into a small hook as shown and run the
hook through the Burner Tube and inside the Burner several times to remove debris.
METHOD 2: Use a bottle brush with a flexible handle and run the brush through the
Burner Tube and inside the Burner several times to remove any debris.
METHOD 3: Use an air hose to force air through each burner Tube. The forced air should
pass debris or obstructions through the Burner and out the Ports.
Regardless of which Burner cleaning procedure you use, we recommend you also complete the
following steps to help prolong Burner life.
1. Use a fiber pad or nylon brush to clean the entire outer surface of each Burner until free of
food residue and dirt.
2. Clean any clogged ports with a stiff wire, such as an open paper clip.
3. Inspect each Burner for damage (cracks or holes) and if such damage is found, order and
install a new Burner. After installation, check to ensure that the Gas Valve Orifices are
correctly placed inside the ends of the Burner Tubes. Also check the position of your Spark
Electrode.
WARNING
For safe operation ensure the Gas Valve Assembly Orifice is inside the Burner Tube before
using your grill. See figure. If the Orifice is not inside the Burner Tube, lighting the Burner may
cause explosion and/ or fire resulting in serious bodily injury and/or property damage.
!
!
Figure 1
