Ranger RP-30FCH, Инструкция по установке и эксплуатации

Страница: 14 / 32

RP-30FCH Oil Filter Crusher
14
P/N 5900097 — December 2020 — Rev. B
Assemble the Stand
The Stand comes disassembled (to protect the components during shipping).
The following graphic shows the components of the Stand.
To assemble the Stand:
Arrange all of the Stand components near where you are going to assemble it.
Lay the Top flat on the ground, with the inside facing up.
Attach the Left Top Legs (2) and Right Top Legs (2) to the Top using the included M6 Hex Bolts,
M6 Flat Washers, Split Lock Washers and M6 Nuts.
Important : The Legs look similar but they are not interchangeable. The Tops are different from
the Bottoms and the Left Legs are different from the Rights Legs. We recommend
laying them out to make sure you have the right sections in the right place before
connecting them.
Connect a Small Leg (4) to each Leg that you just installed, and then connect the Left Bottom
Legs (2) and Right Bottom Legs (2) to the corresponding Legs.
Attach the Top Supports (2) and Bottom Supports (2) to the Stand.
Attach the Diagonal Leg to the top of the Stand, put the Stand Support in place near the
bottom of the Stand, then secure the bottom end of the Diagonal Leg and Power Unit Support
in place using the same hardware.
Move the Stand to the upright position.