Ranger RFJ-2TX, Инструкция по установке и эксплуатации

Страница: 6 / 12

2-Ton Long-Reach Floor Jack
6
P/N 5900387 — Rev. B2 — May 2020
Setup
This section describes how to get your Floor Jack ready for use.
To set up your Floor Jack :
1. Remove the Floor Jack from the box.
2. Insert the Handle into the Handle Socket and tighten the Bolt in place.
Removing Air
Before putting your Floor Jack in operation, remove any trapped air from the Hydraulic System.
To Remove Air from the Hydraulic System :
1. Open the Release Valve at the top of the Handle and turn it counter-clockwise.
2. Pump the Handle quickly 6-8 times.
3. Close the Release Valve by turning the Handle clockwise.
If the Lift Arm is raised, the Floor Jack is ready for use. If the Lift Arm is not raised, simply repeat
this procedure.