- 10 -
OPERATION
A
FREQUENCY CHART
Channel
Channel Frequency
Channel
Channel Frequency
1 26.965
MHz 21 27.215
MHz
2 26.975
MHz 22 27.225
MHz
3 26.985
MHz 23 27.255
MHz
4 27.005
MHz 24 27.235
MHz
5 27.015
MHz 25 27.245
MHz
6 27.025
MHz 26 27.265
MHz
7 27.035
MHz 27 27.275
MHz
8 27.055
MHz 28 27.285
MHz
9 27.065
MHz 29 27.295
MHz
10 27.075
MHz 30 27.305
MHz
11 27.085
MHz 31 27.315
MHz
12 27.105
MHz 32 27.325
MHz
13 27.115
MHz 33 27.335
MHz
14 27.125
MHz 34 27.345
MHz
15 27.135
MHz 35 27.355
MHz
16 27.155
MHz 36 27.365
MHz
17 27.165
MHz 37 27.375
MHz
18 27.175
MHz 38 27.385
MHz
19 27.185
MHz 39 27.395
MHz
20 27.205
MHz 40 27.405
MHz
- 11 -
OPERATION
A
PROCEDURE TO RECEIVE AND TRANSMIT
A.
MICROPHONE
The receiver and transmitter are controlled by the push-to-talk switch on the microphone.
Press the switch and the transmitter is activated, release switch to receive. When
transmitting, hold the microphone two inches from the mouth and speak clearly in a
normal voice. This transceiver comes complete with a low impedance dynamic
microphone.
B.
PROCEDURE TO RECEIVE
1.
Be sure that power source, microphone and antenna are connected to the proper
connectors before going to the next step.
2.
Turn
VOL
knob clockwise to apply power to the radio.
3.
Set the
VOL
for a comfortable listening level.
4.
Set the
MODE
switch to the desired mode.
5.
Listen to the background noise from the speaker. Turn the
SQ
knob slowly clockwise
until the noise just disappears. The
SQ
is now properly adjusted. The receiver will
remain quiet until a signal is actually received. Do not advance the control too far or
some of weaker signals will not be heard.
6.
Set the
CHANNEL
selector switch to the desired channel.
7.
Set the
RF GAIN
control fully clockwise for maximum RF gain.
8.
Adjust the
CLARIFY
control to optimize AM signals.
C.
PROCEDURE TO TANSMIT
1.
Select the desired channel of transmission
2.
Set the
MIC GAIN
control fully clockwise.
3.
If the channel is clear, depress the push-to-talk switch on the microphone and speak in
a normal voice.