Installation:
1.
Screw studded rod (D) into the base of the tap (A).
2.
Place the upper seal (C) into the base plinth (B) then place the base plinth (B) onto the bottom of the tap (A).
3.
Screw the hot & cold water tail pipes (I & J) into the base of the tap (A) as shown.
4.
Place the mixertap (A), base plinth (B) and upper seal (C), onto the sink/worktop, passing the tail pipes (I & J) and studded rod (D) through the tap hole.
5.
Pass the triangular stabiliser (E), lower gasket (F) and then metal horseshoe (G) over the studded rod (D) and around the flexible tail pipes (I & J)
6.
Fasten the fixing nut (H) securely onto the fixing stud (D) to fix the tap (A) into its correct location.
7.
Connect the hot and cold tail pipes (I & J) to the water mains using ½” BSPx15mm compression fittings.
Key:
Description:
Qty.
A
Mixertap body
1
B
Base plinth
1
C
Upper seal
1
D
Fixing stud
1
E
Triangular stabilising bracket
1
F
Lower gasket
1
G
Metal horseshoe
1
H
Fixing nut
1
I
Hot Flexi tail
1
J
Cold Flexi tail
1
After installation:
Once you have visually checked the installation of the new tap and
all connections, ensure that all other fittings are closed except the
new tap which should be left open.
Turn on your water heating system and ensure that your mains
stopcock is open. Reconnect both the hot and cold water supplies
to this fitting.
Check the function of flow and function of hot, cold and mixed
water.
Turn off the tap and check carefully for any leaks around all
connections on the fitting and adjoining plumbing.
If possible return to the installation after a longer period to double
check for slower leaks. If pressure testing equipment is available
check the installation to the maximum recommended pressure.
Clean the tap to remove any marks created during installation as
instructed then place a bag over the product to protect the tap until
it is ready for use.
The installation should be periodically checked for damage, if the
property is left unattended for a prolonged period we recommend
isolating water supplies.
