13
Condenser
The condenser underneath the cabinet does not require
frequent cleaning; however, satisfactory cooling depends on
adequate ventilation over this heat exchanger. It is recom-
mended to annually clean the condenser by vacuuming and
brushing. To access the condenser, the unit must be pulled
out from the installation, and the lower machine compart-
ment access cover removed.
Disconnect the power cord before removing the access
cover.
Be sure that nothing obstructs the required air flow openings
in front of the cabinet. At least once or twice a year, brush
or vacuum lint and dirt from the front grille area
(see page 3).
Cabinet
The stainless steel cabinet can be washed with either a stain-
less steel cleaner or a mild soap and water and thoroughly
rinsed with clear water. NEVER use abrasive scouring clean-
ers. Painted surfaces can be cleaned with mild soap and
water.
Interior
Wash interior compartment with mild soap and water. Do
NOT use an abrasive cleaner, solvent, polish cleaner, or
undiluted detergent.
Wine Shelves
The racks may be cleaned with mild soap and water and a
soft cloth. Do NOT use any abrasive cleaners. See below
for instructions for removing the wine shelves.
Door Gasket
The vinyl gasket may be cleaned with mild soap and water,
a bicarbonate of soda solution, or a mild scouring powder.
Removing the Wine Shelves.
Model RDZ60 (Dual Zone Wine Storage unit): Unload wine
from the shelf to be removed. Pull the shelf all the way out
until it stops. Lift up on the front of the shelf so the wheel on
the shelf clears the track fastened to the liner and pull the
shelf the rest of the way out.
All other models: Unload wine from the shelf to be removed.
Pull the shelf all the way out until it stops. At the front of the
drawer slide just under the shelf there is a plastic block (see
Figure 14). Push this block to the rear to release the slide.
Repeat on other side of the shelf. Lift the front of the shelf
and pull away from the slides to remove the shelf.
Reverse this procedure to install the shelf. Be sure to move
the plastic block to the forward position after installing the
shelf.
Figure 14
Plastic Block on
bottom front of slide
CARE AND CLEANING
